Prev

Simulate the G-Code

Next
I then take the G-Code produced by SheetCam and use CutViewer Mill to verify the G-Code and ensure it's going to produce the correct part. You can see the tabs in this screenshot. CutViewer will also check for collisions (i.e. trying to rapid through uncut material). It doesn't have any capability to check for collision with clamps (and I've run into my clamps a few times :) You can also do cross sections and take measurements from the simulation as well. CutViewer Mill is also being run on my linux box using wine. Bigger...
Prev Index Next

Home - Machinist - CNC - Index

Copyright 2007 by Dave Hylands